User's Manual

ManualsBrandsATD Tools ManualsCarbon Monoxide AlarmATD Tools Carbon Monoxide Alarm ATD3699

Replacement Parts

Item Part Number

Sensor with Filter

PRT3700-01

Filter Kit

PRT3700-02

Test Vial

PRT3700-03

Carrying Case

PRT3699-CASE

Instruction Manual

PM-MAN0010

RETURN FOR REPAIR POLICY

Every effort has been made to provide reliable, superior quality

products. However, in the event your instrument requires repair,

forward unit to Service Center freight prepaid to the address below

with return address, phone number and/or email address.

SERVICE CENTER

2651 W 81st Street

Hialeah, FL 33016

WARRANTY POLICY

The ATD3699 Refrigerant Gas Leak Detector is warranted to be

free of defects in materials and workmanship for a period of two

years from the date of purchase including an industry first two year

warranty on the sensor. This warranty applies to all repairable

instruments that have not been tampered with or damaged through

improper use including unauthorized opening of the unit. Please

ship warranty units that require repair freight prepaid to Service

Center along with proof of purchase, return address, phone number

and/or email address.

Model ATD3699

Refrigerant Gas Leak Detector

User Manual

Detects all CFC, HFC, HCFC

Refrigerants including blends

Design Certified to meet

SAE J2791

and EN14624

For R134a

Summary of content (4 pages)

PAGE 1
Replacement Parts Item Sensor with Filter Filter Kit Test Vial Carrying Case Instruction Manual Part Number PRT3700-01 PRT3700-02 PRT3700-03 PRT3699-CASE PM-MAN0010 Model ATD3699 Refrigerant Gas Leak Detector Detects all CFC, HFC, HCFC Refrigerants including blends RETURN FOR REPAIR POLICY Every effort has been made to provide reliable, superior quality products.
PAGE 2
INTRODUCTION The ATD3699 features a long life heated sensor technology that is designed to detect the more current and difficult HFC refrigerants such as R-134a, R-410a, R-407c, R-507, and R-404c in addition to all HCFC (R22) and CFC (R12) refrigerants including SNAP approved hydrocarbon blends. The ATD3699’s unique digital leak size indicator takes the guesswork out of whether or not to repair a small leak.
PAGE 3
ATD3699 Control Panel Maintenance Batteries: Install Batteries: Remove screw located at rear end of unit and pull down hinged battery door to open as shown. Always insert all four batteries into the battery compartment in the same direction. Note polarity mark on the inside of the battery door for proper battery orientation. Polarity Mark Low Battery Indicator Sensor: Replace Filter: Unscrew sensor tip as shown to replace filter.
PAGE 4
Leak Size Indicator The digital leak size indicator remains off normally but once a leak is detected, a number from 1-9 will be displayed for all HFC and HCFC refrigerants regardless of the sensitivity setting. The number will continue to increase or decrease depending on the amount of refrigerant sensed. The maximum value will be displayed once the leak source has been located. The table below can be used to approximate the size of leak: Maximum # displayed 1 -3 4-6 7-9 Leak Size (oz/yr) < 0.1 0.1 to 0.