ATD-10535 7 AMP Variable Speed Reciprocating Saw Owner’s Manual Manufactured in China To ATD Tools, Inc.
TECHNICAL SPECIFICATIONS Voltage: 120V Frequency: 60Hz Power input: 7 Amps No load speed: 600-2400/min Max. Cutting thickness: 5.9'' Stroke length: 1-3/16'' Weight: 8.8 lbs Lpa (sound pressure level): 90.2dB(A) Lwa (sound pressure capacity): 103.2dB(A) Vibration value: 10,675 m/s PRODUCT INFORMATION 1. Blade 2. Footplate 3. Blade clamp screw 4. Trigger switch 5. Speed controller 6. Trigger lock button 7. Mains lead 8.
IMMEDIATELY SWITCH OFF THE TOOL IF THE FOLLOWING CONDITIONS EXIST: • Excessive sparking of the carbon brushes in the collector. • Interruption in the main power, main lead or main lead damage. • Switch is faulty. • Smoke or smell of scorched or burnt insulation. ELECTRICAL SAFETY Always check that the power supply corresponds to the voltage on the rating plate. Your tool is double insulated in accordance with EN 50144; therefore no ground wire is required.
ADJUSTING THE FOOT PLATE ANGLE • To allow the foot plate to securely rest on the work piece, the angle of the footplate can be adjusted as shown in the diagram. • The footplate can also be extended by loosening the two footplate length adjustment screws using the 4 mm hexagon key and then pulling the footplate out to the required length. Ensure the footplate adjustment screws are secure before resuming work. SAWING TIPS • Adjust saw blade and stroke rate to suit the material to be processed.
TROUBLESHOOTING There are no user serviceable parts in this unit. Any repairs or servicing should be carried out by qualified service engineers. If you are having problems with your tool, below are a few common solutions: 1. The electromotor gets hot: • The cool ventilation slots in the motor are stopped up with dirt. - Clean the cool ventilation slots. • The motor is defective. - Have your tool repaired or checked by your local ATD dealer. 2. Tool does not work when hooked up to power.
FAULTS Should a fault occur, e.g. after wear of a part, please contact the place you purchased this tool. In the back of this manual you find an exploded view showing the parts that can be ordered. It is recommended that the tool only be repaired by an experienced technician. ENVIRONMENT In order to prevent the tool from damage during transport, it is delivered in a sturdy packaging. Most of the packaging materials can be recycled. Take these materials to the appropriate recycling locations.
