User's Manual

6
Use of Extension Cords
USE ONLY THREE-WIRED EXTENSION CORDS that have 3-pronged plugs and 3-holed outlets that
accept the tool’s plug. Repair or replace damaged or worn cords immediately.
Be sure your extension cord is properly wired and in good condition. Do not use damaged extension
cords. Always replace a damaged extension cord.
When using an extension cord, be sure to use one heavy enough to carry the current your product will
draw. An undersized cord will cause
a drop in line voltage, resulting in loss of power and overheating. The
table below shows the correct size to use according to the cord length and the amperage draw of the tool
(specified on the nameplate). When in doubt, use the next heavier gauge. The smaller the gauge number,
the heavier the cord. (AWG = American Wire Gauge).
Minimum Gauge for Extension Cords (AWG)
(when using 120 volts only)
Ampere Rating
Total Length of Cord in Feet (meters)
More Than
Not more Than
25’ (7.6m)
50’ (15m)
100’ (30.4m)
150’ (45.7m)
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not Recommended
Use a separate electrical circuit for your tools. This circuit should not be less than a #12 gauge wire, and
should be protected with a 15 A time-lag fuse. Before connecting the motor to the power line, ensure the
switch is in the OFF position and the electric current is rated the same as the current stamped on the
motor’s nameplate. Running at a lower voltage will damage the motor and is not covere d by warranty.
Before You Start – Package Contents
Left work rest------------------------------------------------------- 1
Right work rest----------------------------------------------------- 1
Plain eye shield-----------------------------------------------------1
Magnifying eye shield---------------------------------------------1
Eye shield adjusting knob ---------------------------------------2
Eye shield mounting rod – one left, one right
Eye shield assembly mounting bolt M6x30------------------2
Eye shield assembly mounting washer D6------------------2
Eye shield assembly mounting locking washer D6--------2
Work rest fixing knob----------------------------------------------2
Work rest plain washer D5 ------------------------------------- 2
Work rest lock washer D5 ---------------------------------------2
Coolant tray-----------------------------------------------------------1
Spark deflector------------------------------------------------------2
Spark deflector adjusting screw assembly ------------------2