ATD-10503 Angle Grinder Instruction Manual
Technical Data Model: ATD10503 Rated voltage frequency: AC120V 60Hz Input power: 750W No-load speed: 11,000 RPM Wheel: 4.5” Arbor size: 5/8”-11 UNC Approximate Weight: 2.5KGS (excluding packaging) Safety Instructions Warning: When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury, including the following. Read all these instructions before operating this product and save these instructions.
hand and it frees both hands to operate the tool. Do not strain to reach the work area Keep proper footing and balance at all times. Maintain tools with care Keep cutting tools sharp and clean for better and safer performance. Follow instructions for lubrication and changing accessories. Inspect tool cord periodically, and if damaged, have it repaired by an authorized service facility. Inspect extension cords periodically and replace, if damaged. Keep handles dry, clean and free from oil and grease.
manufacturer’s instructions • Be sure that the abrasive product is correctly mounted and tightened before use. Run the tool at no-load for 30 seconds in a safe position. Stop immediately if there is considerable vibration or if other problems are detected. If this condition occurs, check the machine to determine the cause and, if necessary, change the abrasive wheel. • Do not use separate reducing bushings or adaptors to adapt large holes in abrasive wheels.
