User's Manual

ASSEMBLY

You will need an assortment of small hand tools to complete assembly of this Masking

Station.

1. Find a suitable assembly area, and arrange the parts for the masking station where they

can easily worked with.

2. Insert one Front Frame (07) into one Rear Frame (05) as shown in Figure 1. Insert the

swaged end of the Front Frame into the curved portion of the Rear Frame near the

handle. Be sure the lock buttons on the front frames fit into the holes in the rear frames.

3. Assemble the Large Bottom Tray (03) between the two frame assemblies. Attach using

two screws, four washers and two nuts per side.

4. Insert the Axle (01) through the bottom holes in the Rear Frames, as shown in Figure 2.

Snap on one C-clip per side into the groove just outside each rear frame.