User's Manual

6
10. Repeat step 9 using the hole below the hand grip in the right rear frame.
11. Repeat step 9 using the holes located on the front frames just above the large bottom
tray.
12. Select one of the bolts you have just installed, and thread a wing nut and washer half
way onto the bolt. Thread the wing nut on so that the flat side of the wing nut faces to
the inside of the frame assembly. See detail photo
13. Insert the metal bushings into the center of the tape roll holders.
14. Place one tape roll holder with the metal bushing installed onto one of the bolts. Face
the tape roll holder so the flanges are nearest to the frame. Thread on a washer and
wing nut to the bolt as shown in the detail photo. Tighten against the tape roll holder.
15. Repeat steps 12-14 to install the remaining three tape roll holders.
16. Install both cutting blades (08) onto the front frames as shown in Figure 6. Mount upper
blade with the cutting edge down, and lower blade with cutting edge up. Assemble using
two screws, four washers, and two nuts per paper cutting blade.