user manual

ATD-6900

9PCS HVLP SPRAY GUN SET

INSTRUCTION MANUAL

Read this manual carefully and understand it completely.

Retain manual for future use.

Always follow safety precautions to prevent personal injury and/or damage

to the equipment.

Illustrations and photos are intended for reference only. Actual product may vary.

Specifications are subject to change without notice.

Important Safety Instructions

1. Always wear eye protection, gloves and respirator to prevent against harmful

vapors while spraying.

2. Never use oxygen or any other combustible or bottle gas as a propellant.

Explosion and serious injury or death may result.

3. Many paints and solvents can be highly flammable. Please use the spray gun

only in well-ventilated areas, do not smoke or use near open flame.

4. Always disconnect the paint gun from air supply when not in use and during

maintenance. For emergency stopping and to prevent unintended operation, a

valve near the gun is recommended.

5. Inspect the tool before each use to ensure there is no leakage or misaligned

parts. Be sure the trigger moves freely.

6. Never use halogenated hydrocarbon solvent, as it can chemically react with

aluminum and zinc parts of this tool.

7. Do not make any modifications to this tool.

Figure 1:

PAGE 1
ATD-6900 9PCS HVLP SPRAY GUN SET INSTRUCTION MANUAL Read this manual carefully and understand it completely. Retain manual for future use. Always follow safety precautions to prevent personal injury and/or damage to the equipment. Illustrations and photos are intended for reference only. Actual product may vary. Specifications are subject to change without notice. Important Safety Instructions 1. Always wear eye protection, gloves and respirator to prevent against harmful vapors while spraying. 2.
PAGE 2
Operating Instructions POWER SOURCE This tool operates best on a clean, dry supply of compressed air delivered at 29 to 50 psi. Use of a moisture trapping air filter (ATD-7812) is highly recommended as moisture or foreign matter can damage the internal parts of this tool. CAUTION: All air pressure in the system should be rated at 29 to 50 psi. Higher or lower pressure can adversely influence the operation or cause damage to this tool.
PAGE 3
Figure 3 – INCORRECT Figure 4 – CORRECT 3
PAGE 4
ADJUSTMENT 1. Fine-tune the gun to your desired working settings of spray patterns, fluid output and degree of paint atomization using the three controls illustrated in Figure 5. Figure 5 Maintenance To clean the gun, pour any leftover paint back into its container. Using thinner, clean out the paint cup and cap. Spray some thinner through the gun to clean the spray head, needle and nozzle. Spray until thinner comes out clean.
PAGE 5
PAGE 6
PAGE 7
PAGE 8