Manual

ManualsBrandsAtdec ManualsComputersSit-to-Stand Adjustable Workstation

Lift Mechanism

Keyboard Tray

Keyboard PanelWork Surface

Support

Bracket

Clamp Plate

Keyboard Bracket

Clamp

Bracket

Pressure

Plate

G H I

Spacer (x2)

Large Allen Key Small Allen Key Clamp Screw (x2) M6X8 (x10)

M6X12 (x10)M6X10 (x2) M6X35 (x2)

J K L M

ON P Q

Hardware

Installation Instructions

Sit-to-Stand Workstation

Desk Clamp

Step 1. Check components

Component Checklist

A-STSCB

IMPORTANT INFORMATION

! IMPORTANT - Install as per Installation Instructions

! This product is compatible with Visidec

Focus and SYSTEMA

monitor mounts.

! This product supports a total maximum load of 28.6lbs (13 Kg ).

! The manufacturer accepts no responsibility for incorrect installation.

! Ensure any required electrical/data cables have sufﬁcient length to accommodate the sit-to-stand workstation’s movement.

Check that you have received all parts against the Component Checklist.

Summary of content (4 pages)

PAGE 1
Installation Instructions A-STSCB Sit-to-Stand Workstation Desk Clamp Component Checklist A E B Lift Mechanism F Keyboard Tray C Keyboard Panel Work Surface D Keyboard Bracket Clamp Plate Hardware J K Large Allen Key N G Clamp Bracket H Pressure Plate I L M Small Allen Key Clamp Screw (x2) O P M6X8 (x10) Q Support Bracket M6X10 (x2) M6X12 (x10) M6X35 (x2) Spacer (x2) IMPORTANT INFORMATION ! ! ! ! ! IMPORTANT - Install as per Installation Instructions This product is compa
PAGE 2
Step 2. Attach lift mechanism to work surface Lift Paddle Alternate Position The lift paddle can be attached on the left or right side of the work station. K A O Caution Avoid pressing the lift paddle until Step 5. Cable Routing Route the lift paddle cable through the slot in the plates on the lift mechanism (A) K P Lift Paddle Q B Step 3. Attach keyboard bracket and tray 3.1 3.3 C D O O E K M K K 3.2 Step 4. Assemble Clamp 4.1 Option 1 For desk thickness less than 1.57” (40mm) 0 - 1.57” 4.
PAGE 3
Step 5. Raise lift mechanism Depress the lift paddle to raise the lift mechanism. Caution When pressing the paddle, the lift mechanism will rise. Keep clear as the arm rises. Step 6. Determine placement on desk A Keyboard tray must clear the front edge of the desktop when the workstation is lowered. ≤13.8” F Adjust the position of the lift mechanism (A) on the clamp plate (F) until the measurement shown above is less than or equal to 13.8” (350mm). Step 7. Attach lift mechanism to clamp plate 7.2 7.
PAGE 4
Step 8. How to adjust from sitting to standing Push While gripping onto the sides of the work surface, depress the lift paddle to adjust the height of the work station. Step 9. Adjust lift mechanism 45˚ 9.1 Position the workstation at mid height While gripping onto the sides of the work surface, depress the lift paddle and adjust the angle of the lift mechanism to 45° from the table. 9.2 Adjust the amount of lift assistance. The workstation should not fall when the lift paddle is depressed.