Manual

Lift Mechanism

Tabletop Base

Keyboard Bracket

Keyboard Tray

Keyboard Panel

Work Surface

Spacer (x2)Square Pad (x2)

Round Pad (x4)

Large Allen Key Small Allen Key

M6X8 (x2) M6X25 (x4)M6X12 (x10) M6X35 (x2)

H I J

LK M N O

Hardware

Installation Instructions

Sit-to-Stand Workstation

Freestanding

Step 1. Check components

Component Checklist

A-STSFB

Check that you have received all parts against the Component Checklist.

IMPORTANT INFORMATION

! IMPORTANT - Install as per Installation Instructions

! This product is compatible with Visidec

Focus and SYSTEMA

monitor mounts.

! This product supports a total maximum load of 28.6lbs (13 Kg ).

! The manufacturer accepts no responsibility for incorrect installation.

! Excessive pressure on the Keyboard Tray may result in the workstation tipping over.

! Ensure any required electrical/data cables have sufﬁcient length to accommodate the sit-to-stand workstation’s movement.

PAGE 1
Installation Instructions A-STSFB Sit-to-Stand Workstation Freestanding Component Checklist A Lift Mechanism B Work Surface D Keyboard Bracket C Keyboard Panel Hardware E Keyboard Tray F Tabletop Base G H Square Pad (x2) K Round Pad (x4) I Spacer (x2) L M J Large Allen Key N Small Allen Key O M6X8 (x2) M6X12 (x10) M6X25 (x4) M6X35 (x2) IMPORTANT INFORMATION ! ! ! ! ! ! IMPORTANT - Install as per Installation Instructions This product is compatible with VisidecTM Focus and SYSTEMAT
PAGE 2
Step 2. Attach lift mechanism to work surface Lift Paddle Alternate Position The lift paddle can be attached on the left or right side of the work station. J A M Caution Avoid pressing the lift paddle until Step 4. J Cable Routing Route the lift paddle cable through the slot in the plates on the lift mechanism (A) O Lift Paddle H B Step 3. Attach keyboard bracket and tray 3.1 G 3.3 C D M M E J L J J 3.2 Step 4.
PAGE 3
Step 5. How to adjust from sitting to standing Push While gripping onto the sides of the work surface, depress the lift paddle to adjust the height of the work station. Step 6. Adjust lift assistance 45˚ I 6.1 Position the workstation at mid height While gripping onto the sides of the work surface, depress the lift paddle and adjust the angle of the lift mechanism to 45° from the table. 6.2 Adjust the amount of lift assistance. The workstation should not fall when the lift paddle is depressed.