Installation manual Owner's manual

Back of Display
5mm Allen Key
4mm Allen Key
Installation Complete
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without noticed. Published 05.06.13 ©
Step 7. Adjust Arm movement if necessary
Step 8. Adjust tilt and roll if necessary
Socket Wrench
LOOSEN
(-kg)
TIGHTEN
(+kg)
-5°
+15°
±5°
WALL
±180°
Position your display to the
desired viewing angle using the
angular movement allowed by
the double ball mount.
Depending on the weight of the
Display, it may be necessary to
make adjustments to the double
ball mount. If the display does
not hold its position, or is too
resistant, adjust the tension
plate located at the rear of the
double ball mount.
To adjust the tension plate, apply
half a turn at a time to each nut.
ENSURE NUTS ARE ADJUSTED
EVENLY.
CHECK THE DISPLAY, and then
adjust again if necessary.
±90°
Step 9. Cable Management
Back of Display
±90°
WALL