Installation manual Instruction Manual

Installation Complete
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 21.03.13 ©
TH-PCP
Component Checklist
Projector Ceiling Plate Accessory
Coach Bolt (x4)
HARDWARE
Tools Required:
• Power Drill
• 4.5mm(0.18”) Drill Bit
• 10mm (3/8”) Socket Wrench Shifter
• Phillips Head Screw Driver
! IMPORTANT - Install Telehook Ceiling Mount as per installation instruction.
! This product supports a maximum load of 100kg (220lbs.).
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received all parts against the component checklist and hardware above.
M6 Washer (x4)
Security
Allen Key
Standard Set
Screw (x2)
Security Set
Screw (x2)
Mount
Step 2. Ceiling Mount
Step 3.
Cover
IMPORTANT! Any structural elements must be capable of
supporting the combined weight of all the equipment and devices
being mounted. If in doubt, consult a structural engineer.
Timber Stud Masonry
Coach Bolt
Screw in 1.5 NPT Pole
(Available from ATDEC)
M6 Washer
Mount
TIP: Use Mount as a drilling template.
Coach Bolt
M6 Washer
Mount
Clip on Cover
Holes to Suit Anchors
NYLON ANCHORS
NOT SUPPLIED
Ø4.5mm x 65mm
deep Drilled Hole
Secure pole by
inserting standard
or security set screws
using supplied Allen
key
Side panels can be
snapped off to provide
cable route
Step 4.
Step 5.
1
2
2
Installation Instructions