Manual

Position your wall plate,
aligning the Contact Edge to
your mark.
Combine both heights to find
the height of the Contact
Edge of the Wall Plate &
mark this on the wall.
Contact Edge with the Hook
Masonry Timber Stud
Coach Screw Coach Screw
Washer
Washer
Ø10mm x 60mm deep
Drilled Hole
Ø8mm x 60mm deep
Drilled Hole
Nylon Anchor
2 coach screws are provided for the TH-VWP-050, TH-VWP-080, TH-VWP-100 and 3 coach screws are provided for the TH-VWP-160.
Ensure all screws are used with exception of where timber studs are spaced too far apart.
3.3.
Step A
Step B
3.4.
IMPORTANT! Any structural elements must be capable of supporting the combined weight of
all the equipment and devices being mounted. If in doubt, consult a structural engineer.
TIP: Use Mount as a drilling template.
Please use a Spirit Level during installation to
ensure that the Wall Plate is LEVEL
X
Y
XZ Y
= +
Step 4. Mount remaining Wall Plates
4.1.
Match Profiles
Repeat Step 3.4 with the following to
install the remaining Wall Plates
Please use a Spirit Level during installation to
ensure that the Wall Plates are LEVEL
4.2.
Height between Wall Plates = Overall Height of Screen
To find the next row height: