Double Oven User Manual

ManualsBrandsAtdec ManualsOvenVFS-DV

op of

Display

There are two mounting hole configurations:

• 75 x 75mm

• 100 x 100mm

from the Hardware supplied to suit

your Displa

your Display

Mounting Screws (x4)

VESA Plate

Component Checklist

VFS-DV

IMPORTANT INFORMATION:

Step 1. Check Components

Step 2. Attach Upright Pole to Base

! IMPORTANT - Install Visidec Freestanding/Double Vertical as per Installation Instructions.

Each Quickshift Donut supports a maximum weight of 12kg (26.5lbs)

! This product supports VESA mounting hole configurations: 75x75mm and 100x100mm.

! The manufacturer accepts no responsibility for incorrect installation.

Display Mounting

Screws

Hardware

Check you have received all parts against the component checklist and Hardware above.

M4x12mm (x8)

VESA Plate (x2)

M4x10mm (x8)

M4x16mm (x8)

Security Screw (x2)

Cable Ball (x4)

Cable Clip (x3)

5/3mm Allen Key

(x1 each)

Installation Instructions

Freestanding l Double Vertical

Base

Upright Pole

TOOLS REQUIRED:

Phillips Head Screw Driver

M8x50mm

Screw (x1)

Step 3. Attach Quickshift Donuts to the Visidec Pole

(Ensure the cable slot faces towards the rear)

TIGHTEN

If the Quickshift Donut requires further

tightening use the supplied 5mm Allen key.

(Visidec 42mm pole shown)

Slot

Groove

Insert

Close the lever to lock the Quickshift

Donut in place.

Slide the Quickshift Donut onto the Pole.

Cable Slot

USER

BACK

TIGHTEN

FIRMLY

Upright Pole

M8x50mm Screw

5mm Allen Key

Attach the Upright Pole to the Base as shown

below. Ensure the Cable Slot faces towards the rear.

Quickshift

Donuts (x2)

Step 4. Attach the VESA Plate to your Display

100mm

75mm

100mm

Back of Display

LOOSEN

(Repeat steps 4 to 7 for each Display)

(Optional)

Summary of content (2 pages)

PAGE 1
Installation Instructions VFS-DV Freestanding l Double Vertical Component Checklist Hardware M4x10mm (x8) Cable Ball (x4) Base VESA Plate (x2) Upright Pole Cable Clip (x3) Quickshift Donuts (x2) M4x12mm (x8) M8x50mm Screw (x1) M4x16mm (x8) TOOLS REQUIRED: Phillips Head Screw Driver (Optional) Security Screw (x2) Display Mounting Screws 5/3mm Allen Key (x1 each) IMPORTANT INFORMATION: ! ! ! ! IMPORTANT - Install Visidec Freestanding/Double Vertical as per Installation Instructions.
PAGE 2
Step 5. Attach your Display to the Quickshift Donut Hook the top of the VESA plate onto the Quickshift Mount. (Optional) Insert the Security Screw, and tighten using a Phillips-head Screwdriver. Press and hold the Release Buttons. Gently push bottom of VESA Plate into Quickshift Mount. Release Buttons to lock in place. HOOK TIGHTEN PUSH Security Screw Back of Display Release Button Phillips-head Screwdriver Step 6.