User Manual

31
InfiniiMax I Series
Performance characteristics
1134A, 1132A, 1131A, 1130A
Bandwidth* 1134A: > 7 GHz 1131A: > 3.5 GHz
1132A: > 5 GHz 1130A: > 1.5 GHz
Rise and fall time (10% to 90%) 1134A: 60 ps 1131A: 100 ps
1132A: 86 ps 1130A: 233 ps
System bandwidth (–3 dB) 1134A w/90604A: 6 GHz
1132A w/90404A: 4 GHz
1131A w/90254A: 2.5 GHz
Input capacitance
1
Cm = 0.10 pF Cm is between tips
Cg = 0.34 pF Cg is to ground for each tip
Cdiff = 0.27 pF Differential mode capacitance = Cm + Cg/2
Cse = 0.44 pF Single-ended mode capacitance = Cm + Cg
Input resistance* Differential mode resistance = 50 kΩ ± 2%
Single-ended mode resistance = 25 kΩ ± 2%
Input dynamic range 5.0 V peak to peak, ± 2.5 V
Input common mode range 6.75 V peak to peak dc to 100 Hz; 1.25 V peak to peak > 100 Hz
Maximum signal slew rate 18 V/ns when probing a single-ended signal
30 V/ns when probing a differential signal
DC attenuation 10:1 ± 3% before calibration on oscilloscope
10:1 ± 1% after calibration on oscilloscope
Zero offset error referred to input < 30 mV before calibration on oscilloscope
< 5 mV after calibration on oscilloscope
Offset range ± 12.0 V when probing single-ended
Offset accuracy < ± 1% of setting when probing single-ended
Noise referred to input 3.0 mV rms
Propagation delay ~6 ns (this delay can be deskewed relative to other signals)
Maximum input voltage 30 V peak, CAT I
ESD tolerance > 8 kV from 100 pF, 300 Ω HBM
Temperature Operating: 5 °C to +40 °C
Non-operating: 0 °C to +70 °C
* Denotes warranted specifications, all others are typical.
1 Measured using the probe amplifier and solder-in differential probe head with full bandwidth resistors.