User`s manual

13
Operating and Safety Instructions
7. OPERATION
7.1. CUTTING OPERATION
7.1.1. Clean the glazing bead mould channels from any burr and foreign
materials. Ensure especially that the glazing bead molds are clean.
7.1.2. Clean all surfaces of the machine from chip and foreign particles. Use eye
glasses for protection.
7.1.3. Check with the appropriate keys that the milling cutters are tightened well.
7.1.4. Check the milling cutters for wear, bending and breaking. Replace them if
damaged.
7.1.5. The CK 410 Automatic Glazing Bead Saw has been designed for cutting of
aluminum and PVC glazing beads at 45° angle for making 90° corner joining.
7.1.6. Connect the air hose with appropriate inner diameter to the air inlet
sleeve. (See FIGURE 5)
7.1.7. Switch the system start switch to “1” (FIGURE 4 – No.18)
7.1.8. Place the profile on the lath mould. Adjust the cutting length of the bead
using the measuring tape and bead support plate.(FIGURE 2-No.6)
7.1.9. Start the electrical motor by pressing the motor start button. (FIGURE4 –
NO.19)
7.1.10. Begin the cutting operation by pressing the cutting start button. The
machine automatically performs cutting operation and returns back to its
starting position. Stop the electirical motor by pressing the motor stop button.
(FIGURE4 – NO:19)
7.1.11. To change the factory setted value of cutting feed, use the adjusting
throttle in the electrica panel. (FIGURE2 – NO.3)
7.1.12. Up-Down adjustment of glazing bead mould can be performed by
adjustment part on the machine. (FIGURE2 – NO.3). First loosen the set square
fixing set screws (FIGURE2 – NO.15). Make the adjustment by turning the knob
up/down. Then again tighten the set screws and nut.
7.1.13. Use emergency button (FIGURE4 – NO.20) by pressing in case of any
irregularities.