User`s manual

Operating and Safety Instructions

7.2. USE OF THE KA 200 EASY MEASURING APPARATUS

7.2.1. With the KA 200 Easy Measuring apparatus it is possible to apply two

different distance measurements serially.

7.2.2. Press the measurement adjustment part against the upper inner section of

the frame, which you want to take the reference measurement from

7.2.3. Press the part Support 1 against the lower inner section of the frame, where

you want to take the reference measurement from, by loosening and moving

the tightening handle. Tighten the handle again to fix the position.

7.2.4. You may repeat the above described operation for the part Support 2 as

well to use it for the second reference measurement.

8. MAINTENANCE, SERVICE AND REPAIR

8.1 STARTING TO WORK

8.1.1. Ensure that the machine table and all kind of parts are clean and dry.

Degrease and dry the machine table. Especially ensure that the holding grips

and handles are clean and dry.

8.1.2. Clean all surfaces of the machine from chip and foreign particles. Use eye

glasses for protection.

8.1.3 Check the milling cutters for wear, bending and breaking. Replace them if

damaged.

8.1.4. Check the air pressure. Adjust the air pressure between 7 – 8 Bar

8.1.5. Check the air filters and the oil level in the conditioner. Fill up oil, if

necessary

Measurement

adjustment

part

Support 1

Support 2