User manual

A
tel
AWP
-
L
Series
CDMA Wireless Phone
User Manual
3F, Building-8,#289 Bisheng Road,
Zhangjiang Hi-Tech Park, Pudong, Shanghai, China, 201204
http://www.asiatelco.com
18
Figure 50 Set Keypad Password-1
 After a new password is entered, a password confirmation dialog box will be
displayed. Re-enter the new password you just input:
Figure 51 Set Keypad Password-2
 If above two passwords are entered properly, you will have a new password.
7 Technical Specifications
Frequency： CDMA 800MHZ
Maximum Transmitting Power： > 23 dBm @ 50 ohm
Receiving Sensibility： < -105dBm/1.23MHz;
External DC Voltage： DC 6.6 V
Operation Temperature： -10℃ ~ +45℃
Ambient Humidity： 0～95％
Storage Temperature： -30
o
C～＋60
o
C
Pressure： 86－106Kpa
8 Quick Troubleshooting Guide
 Unable to send/receive data/fax calls: Check the connections to computer
and verify that necessary software has been properly installed and
configured.
 Moisture or ventilation problems: Visually inspect the Phone body, moisture
can damage the Phone. Ventilation is also very important. Move the Phone
to improve the ventilation as necessary.
 No power: Verify that AC power source and its corresponding circuit
breaker are functioning properly.
 If Phone can’t make data connection:
1. Make sure to follow Modem installation procedures
2. Make sure that you have purchased CDMA1x service from your CDMA
service provider
3. Make sure that both PC’s modem driver and proper software are
installed correctly
 Unable to receive incoming calls:
1. Make sure that the incoming call is not restricted;
2. Make sure the FAX/DATA mode setting is OFF
3. Make sure that your Phone is having good signal reception
 Unable to make outgoing calls:
1. Make sure that the numbers you dialed are not restricted;
2. Make sure that your Phone is having good signal reception
Confirm Password
****