- 16/32 Port Modular MatrixTM KVM Switch User Manual

(F4 ADM: continued)
Setting Function
SET QUICK
VIEW PORTS
This function lets the Administrator select which Ports to include as
Quick View ports.
w To select/deselect a port as a Quick View Port, Double Click the
port you want, or use the Navigation Keys to move the highlight
bar to it, then press [Enter].
w When a port has been selected as a Quick View Port, an
arrowhead displays in the QV column of the LIST on the Main
Screen to indicate so. When a port is deselected, the
arrowhead disappears.
w If one of the Quick View options is chosen for the LIST view
(see F2 LIST, p. 39), only a Port that has been selected here
will display on the List.
w If one of the Quick View options is chosen for Auto Scanning
(see SCAN/SKIP MODE, p. 41), only a Port that has been
selected here will be Auto Scanned.
The default is for no ports to be selected.
SET
ACCESSIBLE
PORTS
This function allows the Administrator to define Operator access to
the computers on the installation on a Port-by-Port basis.
For each Operator, select the target Port; then press the [Spacebar]
to cycle through the choices: F (Full access), V (View Only), or
blank (No access). Repeat until all access rights have been set,
then press [Enter]. The default is F for all users on all Ports.
Note: A blank setting means that no access rights are granted. The
Port will not show up on the User’s LIST on the Main Screen.
SET ACCESS
TIMEOUT
If there is no input from the console accessing a particular port for
the amount of time set with this function, the port is released,
allowing it to be accessed by the other consoles.
To set the timeout value, key in a number from 0 - 255 seconds,
then press [Enter].
If the number is 0 [zero], this function is disabled. The default is 5
seconds.
(Table continues on next page)
2004-08-04
44