- 16/32 Port Modular MatrixTM KVM Switch User Manual

Auto Scanning

Auto Scan switches among all the CPU Ports that are accessible to the current

Operator at regular intervals (see Scan/Skip Mode, p. 41, for information regarding

accessible ports). This function is convenient for automatically monitoring the

activity of the computers on the installation.

Setting the Scan Interval:

The amount of time Auto Scan dwells on each port is set with the Scan

Duration setting of the OSD F3 SET function (see p. 41). You can change the

scan interval before activating Hotkey Auto Scanning, if you wish, with the

following Hotkey combination:

1. Invoke HKM (see p. 51).

2. Key in [T] [n]

Where [T] is the letter T, and [n] is a number from 1-255 that represents the

number of seconds for the dwell time.

The letter T and the numbers display on the Command Line as you key them

in. If you make a mistake, use [Backspace] to erase the wrong number.

3. Press [Enter]

After you press [Enter], you automatically exit HKM, and are ready to

invoke Auto Scanning.

2004-08-04