- km02432.book

Chapter 1. Introduction
7
1. Power LED
Lights to indicate that the KM0216 / KM0432 is powered on.
2. KVM Port LEDs (CPU Port LEDs)
The Port LEDs are multicolored (red/green/amber), and provide status
information about their corresponding KVM ports as follows:
3. Station ID LED
The KM0432's Station ID is displayed here. If this is a single station
installation (see page 17), or the first station of a daisy chain installation
(see page 19), the KM0216 / KM0432 has a station ID of 01.
On a daisy chain installation, the KM0216 / KM0432 auto-senses its
position and displays the Station ID that corresponds to its place in the
chain. (see Port ID Numbering, page 28, for details).
4. System Reset Button
Pressing and holding in this switch for more than three seconds performs a
system reset.
Note: This switch is semi-recessed and must be pushed with a thin
object—such as the end of a paper clip or a ballpoint pen.
5. Firmware Upgrade Recovery Switch
During normal operation and while performing a firmware upgrade, this
switch should be in the NORMAL position. See page 57 for firmware
upgrade recovery details.
Color Condition Indication
Amber Steady Port is selected; connected computer is on
Flashing Port is selected; port is cascaded to a powered on
KVM switch
Red Steady Port is selected; connected computer is off
Green Steady Port is not selected; connected computer is on
Flashing Port is not selected; port is cascaded to a powered on
KVM switch
Off Port is not selected; connected computer is off
km02432.book Page 7 Friday, July 20, 2007 3:12 PM