User manual

CE800B User Manual

5. Make sure both units are connected by the Cat 5e cable, then plug in the

Remote unit’s power adapter.

6. Press and hold the Local unit’s Selection button, then plug in the Local

unit’s power adapter.

7. Wait until both green front panel LEDs on the Local unit are flashing on

and off, then release the Selection button.

8. Make sure the orange LED on the front panel of the Remote unit is on

(indicating that Firmware Upgrade Mode is in effect.

Note: If the LED is not on, or it is blinking, the unit is not ready to be

upgraded. You must repeat steps 6 and 7.