User Manual

CL3800 / CL3700 / CL3100 User Manual
12
No. Component Description
1 Upper Handle
With Release Bar
Pull to slide the LCD module out; push to slide it in.
See Opening / Closing the Console, page 23, for details on
sliding the console in and out
2 LCD Module After sliding the LCD module out, flip up the cover to access
the LCD display.
3 LCD Controls The buttons to control the position and picture settings of the
LCD display are located here. See page 29, for details.
4 LCD On / Off
Button
Push this button to turn the LCD monitor on and off. The
button lights when the LCD monitor is off.
Note: The light indicates that only the monitor is off, not the
attached KVM switch.
5 Firmware
Upgrade Switch
During normal operation and while performing a firmware
upgrade, this switch should be in the NORMAL position. If a
firmware upgrade operation does not complete successfully,
this switch is used to perform a firmware upgrade recovery.
See Firmware Upgrade Recovery, page 41, for details.
6 Firmware
Upgrade Port
The firmware upgrade cable that transfers the firmware
upgrade data from the administrator’s computer plugs into
this 3.5 mm audio jack.
7 Reset Switch Located to the right of the Lock LEDs. Press this recessed
switch in with a thin object to perform a system reset.
8 Lock LEDs The Num Lock, Caps Lock, Scroll Lock LEDs are located
here.
9 Rack Mounting
Ta bs
Rack mounting tabs are located at each corner of the unit.
See The LCD KVM switch is designed for rack mounting. If
the KVM switch is not rack mounted be sure to place it on a
completely flat and firm surface before pulling the device in
or out to prevent damage due to uneven force on the
module., page 16, for details.
10 Power LED Lights (green) to indicate that the unit is receiving power.
11 USB Port The USB port is available to connect a USB peripheral
device (flash drive, CD-ROM drive, etc.) to the console, or a
USB mouse for users who prefer to use an external mouse.
12 Touchpad Standard mouse touchpad.
13 Keyboard Module Standard 105-key keyboard.
14 LED Illumination
Light
Press the Exit/Light pushbutton for two seconds to turn the
LED light ON or Off. (Default: On)