User Manual

CL5800 User Manual

Hotkeys

Console selection on the CL5800 is accomplished with hotkey combinations,

as described in the following table:

Note: 1. Press the keys in sequence – one key at a time. First [Ctrl], then [Alt],

then [Shift], etc.

2. Console selections are not saved. If the CL5800 is powered off, it

reverts to the default setting of both consoles enabled when it is

powered on again.

3. If the KVM switch connected to the CL5800 uses the [Ctrl] [Alt]

[Shift] combination to invoke its hotkey mode, you won't be able to

access any of its hotkey operations because the CL5800 will capture

the combination for console selection first.

Combination Action

[Ctrl] [Alt] [Shift] [P] [C] [Enter] To select normal mode (pc, etc.).

[Ctrl] [Alt] [Shift] [S] [U] [N] [Enter] To select SUN

[Ctrl] [Alt] [Shift]

[u] [p] [g] [r] [a] [d] [e] [Enter]

Activates the Firmware Upgrade Mode.

Note: this Hotkey sequence only works when the

Firmware Upgrade Switch (see page 28) is in the

Normal position.

[Ctrl] [Alt] [Shift] [L] [Enter] Enable Local (LCD) console;

Disable Remote (external) console.

[Ctrl] [Alt] [Shift] [R] [Enter] Enable Remote (external) console

Disable Local (LCD) console.

[Ctrl] [Alt] [Shift] [L] [R] [Enter] or

[Ctrl] [Alt] [Shift] [R] [L] [Enter]

Enable both consoles (default).

[Ctrl] [Alt] [Shift] [F11] [F] [Enter] Set the selected KVM port to full speed USB

[Ctrl] [Alt] [Shift] [F11] [L] [Enter] Set the selected KVM port to low speed USB

[Ctrl] [Alt] [Shift] [U] [M] [Enter] Configures the front USB Port to mouse mode

(Mouse functionality is immediate upon switching to

USB mouse mode).

[Ctrl] [Alt] [Shift] [U] [P] [Enter] Configures the front USB Port to peripheral mode.