User manual

CM1164 User Manual
48
Configuring Display Modes
To configure the PiP (Dual / Triple / Quad) screens, do the following steps:
1. Use the port number that corresponds to a computer and check the channel
window (A, B, C, or D) for it to display in.
2. Alpha. Checking this option affects the transparency for the port’s display
on-screen, enabling you adjust it.
3. PbP. In Picture in Picture mode, Channel A takes up the whole screen
while the rest of the channels are placed on the right side of the display,
partially blocking Channel A’s desktop.
In order to view Channel A without the other Channels overlapping it,
check PbP (Picture by Picture). This shows Channel A in full, in a smaller
resolution that allows all the channels to fit into the display without
overlapping.
For PiP Triple Mode, use the Scan check box to select the channel for
Auto Scanning. The channel selected will auto scan between two
computers when PiP Triple is in use and auto scan is invoked. See Auto
Scanning - Display Modes, page 32, for details.
4. Channel Size. Use the (-) and (+) to change a channel’s size. You can
choose a value from 1 to 3 (maximum size).
Disable Channel
Check a port number that you do not want to show on the screen. The
corresponding channel window for that port number will not appear.
See Channel ID, page 71 for information on channels.