USB DVI Secure KVM Switch CS1182 / CS1184 User Manual www.aten.
CS1182 / CS1184 User Manual FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause interference to radio communications.
CS1182 / CS1184 User Manual User Information Online Registration Be sure to register your product at our online support center: International http://support.aten.com North America http://www.aten-usa.
CS1182 / CS1184 User Manual Package Contents The CS1182 / CS1184 package consists of: 1 CS1182 / CS1184 USB DVI Secure KVM Switch 1 Power Cord 1 User Manual* 1 Quick Start Guide Check to make sure that all of the components are present and in good order. If anything is missing, or was damaged in shipping, contact your dealer.
CS1182 / CS1184 User Manual Contents FCC Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii SJ/T 11364-2006. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii User Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .iii Online Registration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .iii Telephone Support . . . . . . . . . . . . .
CS1182 / CS1184 User Manual Chapter 3. Operation Powering On . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Manual Switching . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Port ID Numbering . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 LED Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Chassis Intrusion Detection . . . . .
CS1182 / CS1184 User Manual About This Manual This User Manual is provided to help you get the most from your CS1182 / CS1184 system. It covers all aspects of installation, configuration and operation. An overview of the information found in the manual is provided below. Overview Chapter 1, Introduction, introduces you to the CS1182 / CS1184 System. Its purpose, features and benefits are presented, and its front and back panel components are described.
CS1182 / CS1184 User Manual Conventions This manual uses the following conventions: Monospaced Indicates text that you should key in. [] Indicates keys you should press. For example, [Enter] means to press the Enter key. If keys need to be chorded, they appear together in the same bracket with a plus sign between them: [Ctrl+Alt]. 1. Numbered lists represent procedures with sequential steps. ♦ Bullet lists provide information, but do not involve sequential steps.
Chapter 1 Introduction Overview The ATEN CS1182 / CS1184 2/4-port USB DVI Dual-Link Secure KVM Switch offers secure and reliable access for any government/military desktop environment where security is imperative by providing safe switching between computers operating on different secure networks. NIAP-certified to EAL2+, the CS1182 / CS1184 provides 2-port / 4-port models for secure desktop workstation use.
CS1182 / CS1184 User Manual Features 2/4-port USB DVI Dual-Link Secure KVM Switch Port selection via Pushbutton only (OSD, hotkey methods are not allowed) to enhance security One USB console controls 2/4 secure computers NIAP-certified – validated to EAL2+ security requirements Restricted USB connectivity – non HIDs (Human Interface Devices) are ignored when switching Isolated channel per port – makes it impossible for data to be transferred between computers Tamper-evident tape – provides a
Chapter 1. Introduction Requirements Console DVI monitor capable of the highest resolution that you will be using on any computer in the installation USB mouse USB keyboard Microphone and speaker Computers A DVI card USB Type A ports keyboard and mouse ports Cables The DVI-D KVM cable sets which are specifically designed to work with this switch are not supplied in the package and require a separate purchase.
CS1182 / CS1184 User Manual Operating Systems Suggested operating systems are shown in the table, below: OS Windows Linux UNIX Novell Version 2000, 2003, 2008, XP, Vista RedHat 9.0 and higher, Fedora Core 4 and higher SuSE 10 and higher Debian 3.1, 4.0 Ubuntu 7.04, 7.10 AIX 4.3 and higher FreeBSD 5.5 and higher Sun Solaris 8 and higher Netware 5.0 and higher Mac OS 9 and higher DOS 6.2 and higher Note: Supports Linux Kernel 2.6 and higher.
Chapter 1. Introduction Components Front View 2 1 3 4 5 Rear View 7 6 8 9 10 11 12 Note: The CS1184 has been used in these illustrations. The front and rear panels of the CS1182 and the CS1184 are the same, except the CS1182 has two ports/port selection pushbuttons and the CS1184 has four.
CS1182 / CS1184 User Manual No. Component Description 1 Port Selection Pushbuttons Pressing a Port Selection Pushbutton brings the focus to the computer attached to its corresponding port. 2 Port LEDs The Port LEDs are built into the Port Selection Pushbuttons. Online – Lights green to indicate that the computer attached to its corresponding port is up and running. Note: The green light for a given port is lit for as long as there is a powered on USB connection between the KVM switch and computer.
Chapter 2 Hardware Setup Before You Begin 1. Important safety information regarding the placement of this device is provided on page 15. Please review it before proceeding. 2. Make sure that the power to all devices connected to the installation are turned off. You must unplug the power cords of any computers that have the Keyboard Power On function. 3. A computer connected to the KVM switch should only be powered on after all of the connections to the device are made (DVI, USB and audio).
CS1182 / CS1184 User Manual Grounding To prevent damage to your installation it is important that all devices are properly grounded. Use a grounding wire to ground the CS1182 / CS1184 by connecting one end of the wire to the grounding terminal, and the other end of the wire to a suitable grounded object.
Chapter 2. Hardware Setup Cable Connection To set up your CS1182 / CS1184 installation, refer to the installation diagram on the following page (the numbers in the diagrams correspond to the steps, below), and do the following: 1. Plug your USB keyboard and USB mouse into the USB console ports located on the unit’s rear panel. 2. Plug your console monitor into the DVI console port located in the unit’s rear panel and power on the monitor. 3.
CS1182 / CS1184 User Manual Installation Diagram 1 3 7 8 Rear View 2 4 USB DVI KVM Cable Set 5 USB DVI KVM Cable Set Front View 6 10
Chapter 3 Operation Powering On When you power on your computers, the CS1182 / CS1184 emulates both a mouse and keyboard on each port and allows your computers to boot normally. When you power on the CS1182 / CS1184, the default selected port at switch power on is the lowest port with a computer connected. The selected computer will be displayed on the console monitor. Note: The default connection is determined by the lowest numbered DVI connection that is powered on.
CS1182 / CS1184 User Manual LED Indication Power Lights blue to indicate that the CS1182 / CS1184 is powered on Online Lights green to indicate that the computer attached to its corresponding port is up and running. Note: The green light for a given port is lit for as long as there is a powered on USB connection between the KVM switch and computer. Selected Lights orange to indicate that the computer attached to its corresponding port has the KVM.
Appendix Safety Instructions General Read all of these instructions. Save them for future reference. Follow all warnings and instructions marked on the device. Do not place the device on any unstable surface (cart, stand, table, etc.). If the device falls, serious damage will result. Do not use the device near water. Do not place the device near, or over, radiators or heat registers. The device cabinet is provided with slots and openings to allow for adequate ventilation.
CS1182 / CS1184 User Manual If an extension cord is used with this device make sure that the total of the ampere ratings of all products used on this cord does not exceed the extension cord ampere rating. Make sure that the total of all products plugged into the wall outlet does not exceed 15 amperes. To help protect your system from sudden, transient increases and decreases in electrical power, use a surge suppressor, line conditioner, or uninterruptible power supply (UPS).
Appendix Technical Support International For online technical support – including troubleshooting and documentation: http://support.aten.com For telephone support, See Telephone Support, page iii: North America Email Support Online Technical Support support@aten-usa.com Troubleshooting Documentation Software Updates Telephone Support http://www.aten-usa.
CS1182 / CS1184 User Manual Specifications Function Computer Connections CS1182 CS1184 2 4 Port Selection Connectors Pushbutton Console Keyboard 1 x USB Type-A F (Black) Video 1 x DVI-I Dual Link F (White) Mouse 1 x USB Type-A F (Black) Audio Speaker Microphone 2 x USB Type-B F (White) 4 x USB Type-B F (White) Video 2 x DVI-I Dual Link F (White) 4 x DVI-I Dual Link F (White) Speaker 2 x Mini Stereo Jack F (Green) 4 x Mini Stereo Jack F (Green) Microphone 2 x Mini Stereo Jack F (Pink
Appendix Limited Warranty IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY EXCEED THE PRICE PAID FOR THE PRODUCT FROM DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE PRODUCT, DISK, OR ITS DOCUMENTATION. The direct vendor makes no warranty or representation, expressed, implied, or statutory with respect to the contents or use of this documentation, and especially disclaims its quality, performance, merchantability, or fitness for any particular purpose.
CS1182 / CS1184 User Manual This Page Intentionally Left Blank 18
Index C Cables, 9 Cable Connection, 9 Components, 5 front view, 5 LEDs, 6 Port LEDs, 6 rear view, 5 D desktop mounting, 7 F Features, 2 G Grounding, 8 grounding screw, 6 L LED Display, 11 LEDs, 11 port LEDs, 6 Power LED, 6 M Manual Switching, 11 N National Information Assurance Partnership, 1 NIAP, 1 Normal Mode Chassis Intrusion Detection, 12 LED Display, 11 Manual Switching, 11 Port ID Numbering, 11 Powering on, 11 O Online Registration, iii P Port ID Numbering, 11 R Requirements, 3 cables, 3 co
