User manual

Chapter 2. Hardware Setup
9
Cable Connection
To set up your CS1182 / CS1184 installation, refer to the installation diagram
on the following page (the numbers in the diagrams correspond to the steps,
below), and do the following:
1. Plug your USB keyboard and USB mouse into the USB console ports
located on the unit’s rear panel.
2. Plug your console monitor into the DVI console port located in the unit’s
rear panel and power on the monitor.
3. Plug your microphone and speakers into the console microphone and
speaker jacks located on the unit’s front or rear panel. The microphone and
speakers plugged into the front panel have priority over those in the rear
panel.
4. Using a KVM cable set (not supplied in the package and should be
purchased separately), plug the DVI connector into any available DVI
socket in the KVM port section of the switch, then plug the accompanying
USB, microphone and speaker connectors into their corresponding USB,
microphone, and speaker sockets.
Note: Verify that all the plugs are in the same KVM Port sockets (all in
Port 1, all in Port 2, etc.). Each socket is marked with an appropriate
icon.
5. At the other end of the cable, plug the USB, video, microphone, and
speaker cables into their respective ports on the computer.
6. Check that the USB seal is still attached to the CAC reader port to prevent
unintended usage.
7. Plug the female end of the power cord into the CS1182 / CS1184's power
socket; plug the male end into an AC power source.
8. Turn on the product and check that the LEDs light up for 1 second.