User Manual
Table Of Contents
- CS1732B / CS1734B User Manual
- Introduction
- Hardware Setup
- Basic Operation
- Keyboard Port Operation
- OSD Operation
- OSD Overview
- OSD Navigation
- OSD Main Screen Headings
- OSD Functions
- F3: SCAN
- F4: SET
- 1. SET TIMEOUT to ON. Key in a value from 1-30 minutes. If SET TIMEOUT is set to OFF, you will not be able to set the SCREEN BLANKER.
- 2. Set the SCREEN BLANKER password. Key in a password that is 8 characters long (allowed characters are A-Z and 0-9). If you have not changed the default password, you can press [Enter] to cancel SCREEN LOCK.
- 3. Set the SCREEN LOCK to ON. Key in Y. If the SCREEN LOCK function is set to ON, a password is needed to the leave the SCREEN BLANKER mode and return to the OSD.
- Keyboard Emulation
- The Firmware Upgrade Utility
- Before you Begin
- 2. Choose the Firmware Upgrade Package you want to install (usually the most recent), and download it to your computer.
- 3. Use the Firmware Upgrade Cable provided to connect a COM port on your computer to the Firmware Upgrade Port of your switch.
- 4. Shut down the computers on your CS1732B / CS1734B installation.
- 5. Invoke Firmware Upgrade Mode (see FIRMWARE UPGRADE, page 33).
- Starting the Upgrade
- Upgrade Succeeded
- Upgrade Failed
- Before you Begin
- Appendix
CS1732B / CS1734B User Manual
4
Requirements
Console
A VGA, SVGA, or Multisync monitor capable of the highest resolution
that you will be using on any computer in the installation.
A USB mouse
A USB keyboard
Computer
The following equipment must be installed on each computer:
A VGA, SVGA or Multisync card.
USB Type A port, or PS/2 keyboard and mouse ports.
Cables
Only cable sets specifically designed to work with this switch may be used to
link to the computers. Two 1.2 m cables sets are provided with the CS1732
B
package. Four (two 1.2 m and two 1.8 m) cable sets are provided with the
CS1734
B package. They use the USB to transfer the keyboard and mouse input
from your console to the computer.
Both switches also support computers that use PS/2 connectors to transfer
keyboard and mouse data. Cable sets with PS/2 connectors, as well as longer
cable sets are available from your dealer. See the following table for details:
Note: The CS1732B / CS1734B's USB hub function only works with USB
cable set connections. It will not work with PS/2 cable set
connections.
Connector Cable Length Part Number
USB 1.2 m 2L-5301U
USB 1.8 m 2L-5302U
USB 3 m 2L-5303U
USB 5 m 2L-5305U
PS/2 1.2 m 2L-5301P
PS/2 1.8 m 2L-5302P