User Manual
Table Of Contents
- CS1732B / CS1734B User Manual
- Introduction
- Hardware Setup
- Basic Operation
- Keyboard Port Operation
- OSD Operation
- OSD Overview
- OSD Navigation
- OSD Main Screen Headings
- OSD Functions
- F3: SCAN
- F4: SET
- 1. SET TIMEOUT to ON. Key in a value from 1-30 minutes. If SET TIMEOUT is set to OFF, you will not be able to set the SCREEN BLANKER.
- 2. Set the SCREEN BLANKER password. Key in a password that is 8 characters long (allowed characters are A-Z and 0-9). If you have not changed the default password, you can press [Enter] to cancel SCREEN LOCK.
- 3. Set the SCREEN LOCK to ON. Key in Y. If the SCREEN LOCK function is set to ON, a password is needed to the leave the SCREEN BLANKER mode and return to the OSD.
- Keyboard Emulation
- The Firmware Upgrade Utility
- Before you Begin
- 2. Choose the Firmware Upgrade Package you want to install (usually the most recent), and download it to your computer.
- 3. Use the Firmware Upgrade Cable provided to connect a COM port on your computer to the Firmware Upgrade Port of your switch.
- 4. Shut down the computers on your CS1732B / CS1734B installation.
- 5. Invoke Firmware Upgrade Mode (see FIRMWARE UPGRADE, page 33).
- Starting the Upgrade
- Upgrade Succeeded
- Upgrade Failed
- Before you Begin
- Appendix
11
Chapter 2
Hardware Setup
Cable Connection
To set up your CS1732B / CS1734B installation, refer to the installation
diagram on the following pages, and do the following:
1. Plug your USB keyboard and USB mouse into the USB Ports located on
the unit's back panel.
2. Plug your monitor into the Console monitor port located on the unit's rear
panel and power on the monitor.
3. Plug your main microphone and speakers into the Console microphone
and 2.1 surround sound speaker jacks located on the unit's front panel. The
microphone and speakers plugged into this panel have priority over those
plugged into the back panel.
4. Using a KVM cable set (provided with this package), plug the custom
SPHD connector into any available KVM Port on the switch and plug the
accompanying microphone and speaker connectors into the KVM Port's
microphone and speaker jacks.
Note: 1. The connectors and jacks are color coded and marked with an
appropriate icon for easy installation.
2. Be sure that all the plugs are in the same KVM Port sockets (all
in Port 1, all in Port 2, etc.).
1. Important safety information regarding the placement of this
device is provided on page 41. Please review it before proceeding.
2. Make sure that the power to all devices connected to the
installation are turned off. You must unplug the power cords of
any computers that have the Keyboard Power On function