User manual

7
Chapter 2
Hardware Setup
Cable Connection
To set up your CS1784 installation, refer to the installation diagrams on the
following pages (the numbers in the diagrams correspond to the steps, below),
and do the following:
1. Plug your USB keyboard and USB mouse into the USB Console Ports
located on the unit’s rear panel.
2. Plug your secondary microphone, speakers, and monitor into the Console
ports located on the unit’s rear panel and power on the monitor.
3. Plug your main microphone and speakers into the Console microphone
and 2.1 surround sound speaker jacks located on the unit’s front panel. The
microphone and speakers plugged into this panel have priority over those
plugged into the rear panel.
4. Using the KVM cable set, plug the DVI connector into any available DVI
socket in the KVM Port section of the switch, then plug the accompanying
USB, microphone and speaker connectors into their corresponding USB,
microphone, and speaker sockets.
Note: Verify that all the plugs are in the same KVM Port sockets (all in
Port 1, all in Port 2, etc.). Each each socket is marked with an
appropriate icon.
5. At the other end of the cable, plug the USB, video, microphone, and
speaker cables into their respective ports on the computer.
1. Important safety information regarding the placement of this
device is provided on page 29. Please review it before
proceeding.
2. Make sure that power to all devices that you will be installing
has been turned off. You must unplug the power cords of any
computers that have the Keyboard Power On function.