User's Manual
Table Of Contents
- EMC Information
- User Information
- Package Contents
- Contents
- About this Manual
- Conventions
- Product Information
- Chapter 1 Introduction
- Chapter 2 Hardware Setup
- Chapter 3 Basic Operation
- Chapter 4 Hotkey Operation
- Hotkey Port Switching
- Hotkey Setting Mode
- Invoking HSM
- Alternate HSM Invocation Keys
- Alternate Port Switching Keys
- Keyboard Operating Platform
- List Switch Settings
- USB Reset
- Hotkey Beeper Control
- Port Switching Keys
- Firmware Upgrade Mode
- Restore Default Settings
- Keyboard Emulation Control
- Mouse Emulation Control
- Mouse Port Switching
- Monitor Re-detection
- HSM Summary Table
- Chapter 5 Keyboard Emulation
- Chapter 6 The Firmware Upgrade Utility
- Appendix
Chapter 1. Introduction
3
Note: 1. Mouse port switching is only supported under mouse emulation
mode with a USB 3-button mouse wheel.
2. Slide the DCC switch to the s position to allow the KVM switch
to receive RS-232 commands via an RJ-45-to-DB9 cable. Please
refer to the CS1942DP_CS1944DP RS-232 Commands
document.
3. HD audio through DisplayPort cannot be switched independently.
4. MST (Multi-Stream Transport) requires either monitors capable
of DisplayPort 1.2 daisy-chaining, or use of a powered
DisplayPort MST Hub. A DisplayPort v1.1a display can be the
last display in a DisplayPort v1.2 chain. The PC source must be
DisplayPort 1.2 compliant.
5. DisplayPort Dual-Mode technology (DP++) does not require an
active adapter for most single display setups. Active DisplayPort
adapters are recommended if you are unsure of the video source's
DP++ compatibility.
6. PC keyboard combinations emulate Mac keyboards. Mac
keyboards only work with their own operating system.