User's Manual
Table Of Contents
- EMC Information
- User Information
- Package Contents
- Contents
- About this Manual
- Conventions
- Product Information
- Chapter 1 Introduction
- Chapter 2 Hardware Setup
- Chapter 3 Basic Operation
- Chapter 4 Hotkey Operation
- Hotkey Port Switching
- Hotkey Setting Mode
- Invoking HSM
- Alternate HSM Invocation Keys
- Alternate Port Switching Keys
- Keyboard Operating Platform
- List Switch Settings
- USB Reset
- Hotkey Beeper Control
- Port Switching Keys
- Firmware Upgrade Mode
- Restore Default Settings
- Keyboard Emulation Control
- Mouse Emulation Control
- Mouse Port Switching
- Monitor Re-detection
- HSM Summary Table
- Chapter 5 Keyboard Emulation
- Chapter 6 The Firmware Upgrade Utility
- Appendix
Chapter 1. Introduction
9
6 DCC Switch This switch is used to specify the Host and Client
when setting up two units in Quad-Display DCC
mode. See Quad-Display (DCC Mode), page 14 for
instructions.
Slide the DCC switch to the s position to allow the
KVM switch to receive RS-232 commands via an
RJ-45-to-DB9 cable. Please refer to the CS1942DP/
CS1944DP RS-232 Commands document.
No. Component Description