User manual

11
Chapter 2
Hardware Setup
Cable Connection
To set up your CS1942 / CS1944 installation, refer to the installation diagram
on page 13 (the numbers in the diagram correspond to the steps below), and do
the following:
1. Plug your USB keyboard and USB mouse into the USB console ports
located on the unit’s rear panel.
2. Plug the console monitor(s) into the Mini DisplayPort console ports
located on the unit’s rear panel and power on the monitors.
Note: Connections may require a DP to mDP adapter.
3. Plug your analog microphone and headphones into the console
microphone and speaker jacks located on the unit’s front panel.
Note: The microphone and headphones plugged into this panel have
priority over those plugged into the rear panel. Analog audio cables
are required on the CPU side for this connection.
4. Plug your analog/digital (Mini-TOSLINK) microphone and speakers into
the audio console ports located on the unit’s rear panel.
Note: Digital sound equipment requires Mini-TOSLINK cables.
1. Important safety information regarding the placement of this
device is provided on page 33. Please review it before
proceeding.
2. Make sure that the power to all devices connected to the
installation are turned off. You must unplug the power cords of
any computers that have the Keyboard Power On function.