User manual

- 11 -
Installation
Setting up the CS62US / CS64US USB KVM Switch is quick and
easy. Refer to the installation diagrams on the following pages
(the numbers in the diagrams correspond to the steps, below)
and do the following:
1. Plug your USB keyboard, USB mouse, and monitor into their
ports on the CS62US / CS64US. These are located on the
side of the CS62US and the front of the CS64US.
Note: When using a wireless keyboard and mouse combo,
the dongle must plug into the CS62US / CS64US’s
keyboard port in order for the hotkeys to function.
2. Plug your speakers into the speaker jack.
3. Plug the USB, video, and audio connectors of the attached
KVM cables into their respective ports on the computers you
are installing.
4. Power on the computers.
Note: The CS62US / CS64US’s power on default is to link to
the first computer that is powered on.
1. Make sure that the power to any device that you
connect to the installation has been turned off. You
must unplug the power cords of any computers that
have the Keyboard Power On function.
2. Make sure that all devices you will be installing are
properly grounded.