User manual

Chapter 12. Maintenance
161
4. Click Ye s to continue. After a short while, the Firmware Upgrade page
comes up:
All the stations, consoles and KVM adapters that are capable of being
upgraded are listed.
Note: Only online stations and consoles, as well as KVM adapters
connected to online devices show up in the list. Offline stations and
consoles, as well as adapters connected to offline devices do not get
upgraded.
5. Make sure there is a check in the checkbox in front of the modules you
want to upgrade. Uncheck the modules that you do not want to upgrade.
6. Click Browse. Navigate to the directory where the firmware upgrade file
is located and select it.
7. Enable or disable Check Firmware Version
 If you enabled Check Firmware Version the current firmware level is
compared with that of the upgrade file. If the current version is equal to
or higher than the upgrade version, a popup message appears, to inform
you of the situation and stops the upgrade procedure.
 If you didn't enable Check Main Firmware Version, the upgrade file is
installed without checking what its level is.
8. Click Upgrade to start the upgrade procedure. As the upgrade proceeds,
progress information is shown on the screen. Once the upgrade completes
successfully, the switch resets itself.
9. Log in again, and check the firmware version to be sure it is the new one.