User manual
Table Of Contents
- KN1108v / KN1116v User Manual
- Introduction
- Hardware Setup
- Super Administrator Setup
- Logging In
- The User Interface
- The Web Browser Main Page
- Laptop USB Console Main Page
- The AP GUI Main Page
- The Local Console GUI Main Page
- The Control Panel
- Port Access
- User Management
- Device Management
- Log
- Maintenance
- Download
- Port Operation
- The Log Server
- Appendix
- Safety Instructions
- Consignes de sécurité
- Technical Support
- Specifications (English)
- Technische Daten (Deutsch)
- Troubleshooting
- IP Address Determination
- IPv6
- Port Forwarding
- Keyboard Emulation
- PPP Modem Operation
- Internal Serial Interface Configuration
- Additional Mouse Synchronization Procedures
- Additional Video Resolution Procedures
- Trusted Certificates
- Self-Signed Private Certificates
- Clear Login Information
- Factory Default Settings
- Serial Adapter Pin Assignments
- Supported KVM Switches
- Supported Power Over the Net™ Units
- Virtual Media Support
- Limited Warranty
KVM Over the NET™ User Manual
98
Accessing the COM Ports
To access the device running on the COM port, double click on its entry in the
sidebar to open the Remote View GUI, as shown below:
The Remote View client has a control panel similar to the one described in the
previous chapter (see The Control Panel, page 52), so you can reference this
for descriptions of the toolbars function.
Depending on the type of device attached to the COM port, not all of the
functions may be enabled.
Note: To configure an attached device’s serial interface parameters from
within any accessed server, see Internal Serial Interface Configuration,
page 253.