User manual
Table Of Contents
- KN1108v / KN1116v User Manual
- Introduction
- Hardware Setup
- Super Administrator Setup
- Logging In
- The User Interface
- The Web Browser Main Page
- Laptop USB Console Main Page
- The AP GUI Main Page
- The Local Console GUI Main Page
- The Control Panel
- Port Access
- User Management
- Device Management
- Log
- Maintenance
- Download
- Port Operation
- The Log Server
- Appendix
- Safety Instructions
- Consignes de sécurité
- Technical Support
- Specifications (English)
- Technische Daten (Deutsch)
- Troubleshooting
- IP Address Determination
- IPv6
- Port Forwarding
- Keyboard Emulation
- PPP Modem Operation
- Internal Serial Interface Configuration
- Additional Mouse Synchronization Procedures
- Additional Video Resolution Procedures
- Trusted Certificates
- Self-Signed Private Certificates
- Clear Login Information
- Factory Default Settings
- Serial Adapter Pin Assignments
- Supported KVM Switches
- Supported Power Over the Net™ Units
- Virtual Media Support
- Limited Warranty
KVM Over the NET™ User Manual
122
Power Management
The Power Management page is used to associate a PON power outlet with a
KVM port on the KVM Over the NET™ switch. Once an association has been
made, the power status of the device attached to the KVM port can be
controlled from the Port Access page, rather than having to control the power
status by opening a separate web session to the PON device.
When the Power Management page comes up, it looks similar to the one below:
Note: This page is only available when a PON device is connected to the
switch.
Adding/Removing Associations:
To associate an outlet with the selected port, do the following:
1. Click Add.
The PON Mapping dialog box comes up with a list of all the outlets
available for association.