User manual
Table Of Contents
- KN1108v / KN1116v User Manual
- Introduction
- Hardware Setup
- Super Administrator Setup
- Logging In
- The User Interface
- The Web Browser Main Page
- Laptop USB Console Main Page
- The AP GUI Main Page
- The Local Console GUI Main Page
- The Control Panel
- Port Access
- User Management
- Device Management
- Log
- Maintenance
- Download
- Port Operation
- The Log Server
- Appendix
- Safety Instructions
- Consignes de sécurité
- Technical Support
- Specifications (English)
- Technische Daten (Deutsch)
- Troubleshooting
- IP Address Determination
- IPv6
- Port Forwarding
- Keyboard Emulation
- PPP Modem Operation
- Internal Serial Interface Configuration
- Additional Mouse Synchronization Procedures
- Additional Video Resolution Procedures
- Trusted Certificates
- Self-Signed Private Certificates
- Clear Login Information
- Factory Default Settings
- Serial Adapter Pin Assignments
- Supported KVM Switches
- Supported Power Over the Net™ Units
- Virtual Media Support
- Limited Warranty
KVM Over the NET™ User Manual
176
Outlet Configuration
The outlet configuration settings that can be made on this page are the same
ones described under Power Management, in the table on page 124.
Click on a setting to drop down the list of choices.
To give more than one outlet the same setting at the same time, click to put
a check mark in front of the outlets you want to configure. When you
change the setting for any one of the outlets, each of the selected outlets
will get the new setting.
To change the setting for all of the outlets at the same time, click to put a
check mark in front of the PON’s name. All of the outlets are selected.
When you change the setting for any one of the outlets, all of the outlets
will get the new setting.