User manual
Table Of Contents
- KN1108v / KN1116v User Manual
- Introduction
- Hardware Setup
- Super Administrator Setup
- Logging In
- The User Interface
- The Web Browser Main Page
- Laptop USB Console Main Page
- The AP GUI Main Page
- The Local Console GUI Main Page
- The Control Panel
- Port Access
- User Management
- Device Management
- Log
- Maintenance
- Download
- Port Operation
- The Log Server
- Appendix
- Safety Instructions
- Consignes de sécurité
- Technical Support
- Specifications (English)
- Technische Daten (Deutsch)
- Troubleshooting
- IP Address Determination
- IPv6
- Port Forwarding
- Keyboard Emulation
- PPP Modem Operation
- Internal Serial Interface Configuration
- Additional Mouse Synchronization Procedures
- Additional Video Resolution Procedures
- Trusted Certificates
- Self-Signed Private Certificates
- Clear Login Information
- Factory Default Settings
- Serial Adapter Pin Assignments
- Supported KVM Switches
- Supported Power Over the Net™ Units
- Virtual Media Support
- Limited Warranty
KVM Over the NET™ User Manual
204
The Toolbar Icons
The meanings of the toolbar icons are explained in the table below.
Icon Purpose
Click to skip to the first accessible port on the entire installation,
without having to recall the Port Access page.
Note: This function is not available on the local console Array
mode.
Click to skip to the first accessible port previous to the current
one, without having to recall the Port Access page.
Note: This function is not available on the local console Array
mode.
Click to begin Auto Scan Mode. The KN1108v / KN1116v
automatically switches among the ports that were selected for
Auto Scanning with the Filter function (see Filter, page 91). This
allows you to monitor their activity without having to switch
among them manually.
Click to skip from the current port to the next accessible one,
without having to recall the Port Access page.
Note: This function is not available on the local console Array
mode.
Click to skip from the current port to the last accessible port on
the entire installation, without having to recall the Port Access
page.
Note: This function is not available on the local console Array
mode.
Click to recall the Port Access page.
Click to close the toolbar.
Click to invoke Panel Array Mode (see Panel Array Mode,
page 208).
Clicking this icon cycles you through the compensation mode
choices used by the Adapter cable that connects the device to
the switch. Make a choice (Short, Medium, Long), depending
on the length of Cat 5e cable used for the connection. The
length of the line in the icon changes to indicate which choice is
selected.