User manual

KVM Over the NET™ User Manual
12
No. Component Description
1 Power Sockets The power cables plug in here.
2 Power
Switches
This standard slide switch powers the unit on and off.
3 PON Port This connector is provided for a Power over the Net™
(PON) unit which allows servers attached to the KVM Over
the NET™ switch to be booted remotely over the net.
See Single Stage Installation, page 19, step 6 for
installation details. Contact your dealer for more information
regarding PON units.
4 Secondary
Serial Port
This port is provided to connect to legacy serial devices via
an SA0142 adapter.
5 Secondary LAN
Port
The cable that connects the unit to the backup network
interface (10/100/1000 Mbps) plugs in here.
6 Grounding
Terminal
The wire used to ground the unit connects here.
7 Modem Port For dial in connection should the unit be unavailable over
the network. See Single Stage Installation, page 19, step 7
for installation details.
8 Primary Serial
Port
This port is provided to connect to legacy serial devices via
an SA0142 adapter.
9 Primary LAN
Port
The cable that connects the unit to the primary network
interface (10/100/1000 Mbps) plugs in here.
10 Local Console
Port(s)
The unit can be accessed via a local console as well as over
the Net. The local console devices (keyboard, monitor and
mouse), plug in here. Any combination of USB and PS/2
keyboards and mice can be used.
Note: For the KN2124v, KN2140v, KN4124v and the
KN4140v units, use the 5-in-1 cable supplied with the
package to connect your console devices to the unit.
11 KVM Ports The Cat 5e cables that link the unit to the KVM Adapter
Cables (which connect to the servers), plug in here.