User manual

Chapter 7. Device Management
73
Authentication & Authorization
The Authentication & Authorization page is used to set up login authentication
and authorization management from external sources.
Disable Local Authentication
Selecting this option will disable login authentication locally on the Power
Over the NET™ device. The device can only be accessed using LDAP,
LDAPS, MS Active Directory, RADIUS, TACACS+, or CC Management
authentication.
RADIUS Settings
To allow authentication and authorization for the Power Over the NET™
device through a RADIUS server, do the following:
1. Check Enable.
2. Fill in the IP addresses and service port numbers for the Preferred and
Alternate RADIUS servers. The default port number for the Preferred
server is 1812; the default port number for the Alternate server is 1645.
Note: Make sure that the port numbers you specify here match the port
numbers used by the RADIUS servers.
3. In the Timeout field, set the time in seconds that the Power Over the
NET™ device waits for a RADIUS server reply before it times out.