Cat 5 USB 2.0 Extender UEH4002 User Guide www.aten.
UEH4002 User Manual Thank you for purchasing the UEH4002. Please read this guide thoroughly. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital service, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
UEH4002 User Manual Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 UEH4002 Product Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 About the UEH4002 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Installation Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Introduction The instructions in this guide assume a general knowledge of computer installation procedures, familiarity with cabling requirements, and some understanding of USB devices. UEH4002 Product Contents Your UEH4002 is packaged with: UEH4002LUSB 2.0 Extender (Local unit) UEH4002R USB 2.0 Extender (Remote unit) USB 2.
UEH4002 User Manual The UEH4002L The Local unit connects to the computer using a standard USB cable. Power for this unit is provided by the USB on the host computer. ITEM TYPE DESCRIPTION 1 Power LED (Blue) LED turns on when power is supplied. Off when no power is supplied. 2 Link LED (Green) Indicates a valid USB link is established between the Local and Remote units over the Cat 5 cabling. 3 Host LED (Green) Indicates that the UEH4002 system is properly enumerated on the host PC.
UEH4002 User Manual The UEH4002R The Remote unit provides USB Type A ports for standard USB devices. It allows you to connect up to four USB devices directly. Additional devices may be connected by attaching USB hubs to the Remote unit. The Remote unit is powered by an external AC adapter and can supply up to 500mA to each USB port. ITEM TYPE DESCRIPTION 1 Device Port (USB Accepts USB device(s). 2 Device LED Type A) (Green/Orange) 3 Indicates when a USB device is connected to the Device Port.
UEH4002 User Manual 7 Power Port Connects to the AC power supply. Required at Remote for proper operation.
UEH4002 User Manual Installation Guide USB extension up to 100m Cat 5 (or better) cable. Before you can install the UEH4002, you need to prepare your site: 1. Determine where the computer is to be located and set up the computer. 2. Determine where you want to locate the USB device(s). 3. If you are using surface cabling, the UEH4002 supports a maximum distance of 100m.
UEH4002 User Manual Connecting the Local unit to the Remote unit Note: To ensure proper operation, it is recommended that only Cat 5 or better, Unshielded Twisted Pair (UTP) cabling be used to connect the Local unit to the Remote unit. The cabling must have a straight-through conductor configuration with no crossovers and must be terminated with 8 conductor RJ45 connectors at both ends. The combined length of any patch cords using stranded conductors must not exceed 10m. With Surface Cabling 1.
UEH4002 User Manual Connecting a USB Device 1. Install any software required to operate the USB device(s). Refer to the documentation for the USB device(s), as required. 2. Connect the USB device to the device port on the Remote unit. 3. Check that the device is detected and installed properly in the operating system. Compatibility The UEH4002 complies with USB 1.1 and USB 2.0 specifications governing the design of USB devices.
UEH4002 User Manual Link LED on Local unit is on, Host LED on Local unit is off. The host computer is not powered on. The Local unit is not connected to the computer (when used with the optional Local AC adapter). The computer does not support USB hubs. The UEH4002 is malfunctioning. UEH4002 units were working, but the Host LED on Local/ Remote units started blinking.
UEH4002 User Manual USB device is attached to Remote USB port but Remote device LED is off. • A USB device must 1. Install the required USB device driver on the computer operating system prior to attaching have the appropriate the USB device to the Remote unit. Please driver installed on see your USB device manufacturer’s website the computer for details. operating system. 2.
UEH4002 User Manual Specifications Range 330 feet (100 meters) over Cat 5e (or better) cable USB device support High-speed devices (480 Mb/s) (USB 2.0) Full speed devices (12 Mb/s) (USB 2.0 & 1.1) Low speed devices (1.5 Mb/s) (USB 2.0 & 1.1) USB hub support Any single chain can include up to 3 USB hubs plus one UEH4002. USB host support EHCI (USB 2.0) and OHCI/UHCI (USB 1.1) Maximum USB devices supported 14 USB devices or 3 USB hubs with 11 USB devices.
UEH4002 User Manual Limited Hardware Warranty ATEN warrants that any hardware products accompanying this documentation shall be free from significant defects in material and workmanship for a period of one year from the date of purchase. ATEN’s hardware warranty extends to Licensee, its customers, and end users.
UEH4002 User Manual Obtaining Warranty Service To obtain warranty service, you must contact ATEN within the warranty period for a Return Material Authorization (RMA) number. ATEN will not accept returns without an authorized RMA number. Be sure you have the serial numbers of the Local unit and Remote unit before calling. Package the product appropriately for safe shipment and mark the RMA number on the outside of the package. The package must be sent prepaid to ATEN.
UEH4002 User Manual Technical Glossary Category 5 (Cat 5) Network Cabling Category 5 cable is commonly also referred to as Cat 5. This cabling is available in either solid or stranded twisted pair copper wire variants and as UTP (Unshielded Twisted Pair) or STP (Shielded Twisted Pair). UTP cables are not surrounded by any shielding making them more susceptible to electromagnetic interference (EMI).
UEH4002 User Manual Table 2 - T568B Wiring PIN PAIR WIRE CABLE COLOR 1 2 1 WHITE/ORANGE 2 2 2 ORANGE 3 3 1 WHITE/GREEN 4 1 2 BLUE 5 1 1 WHITE/BLUE 6 3 2 GREEN 7 4 1 WHITE/BROWN 8 4 2 BROWN 14
