User manual

Hardware Setup
11
Single Station Installation
Note: Make sure that the power to any device that you connect to the
installation has been turned off. You must unplug the power cords of
any computers that have the Keyboard Power On function.
To set up your VE829 installation, refer to the installation diagram on the next
page (the numbers in the diagrams correspond to the steps below), and do the
following:
1. Use HDMI cables to connect the HDMI output ports on up to 4 source
device(s) to the HDMI IN (1-4) ports on the VE829T.
2. Use the provided component adapter cable to connect the component
source device to the YPbPr input port on the VE829T.
3. a. Use an HDMI cable to connect the HDMI input port on the video
display device to the HDMI OUT port on the rear of the VE829T.
b. Use an HDMI cable to connect the HDMI input port on the video
display device to the HDMI OUT port on the rear of the VE829R.
4. (Optional) Connect a PC to the USB port using a mini USB to Type A
USB cable.
5. a. Connect one end of the IR Blaster Cable to the IR Out port on the
VE829T, and attach the IR Blaster “heads” to the video source devices for
IR remote control operation on the Receiver side.
Note: Refer to the User Manual for instructions on how to attach the IR
Blaster heads to your source devices.
b. Connect the IR Sensor Extender Cable to the IR In port on the VE829R,
and attach the IR sensor to a visible area for IR remote control operation.
6. Power on the VE829T / VE829R:
a. Plug the provided power adapter into an appropriate DC power source;
plug the power adapter cable into the Power Jack on the VE829T.
b. Plug the provided power adapter into an appropriate DC power source;
plug the power adapter cable into the Mini USB port on the VE829R.
Note: If both Transmitter and Receiver Power LEDs are red (standby
mode), press the POWER button on the Receiver to wake up both
units automatically.