User manual

Hardware Setup

IR Blaster Extender Cable Setup

To use the remote controls for your input source devices (i.e., DVD player,

game console, Set-top box, etc.) from the Receiver side, use the provided IR

Blaster Extender Cable and IR Sensor Extender Cable. This setup conveniently

enables a user to control the input source devices even while physically located

up to 100 feet away them. Do the following steps for your units:

Transmitter

1. Connect one end of the IR Blaster Extender Cable to the IR Out port on

the VE829T.

2. Attach the IR Blaster heads to the input source device panels –

specifically, over the IR sensor of the audio/video device.

Receiver

3. Connect one end of the IR Sensor Extender Cable to the IR In port on the

VE829R.

4. Attach the IR sensor to a visible area where you can point your IR remote

control (i.e. front panel of the display device or against a wall).

Note: The VE829 IR sensors support 38 KHz, 47 KHz and 56 KHz remote

signal protocol.