User manual

Basic Operation
17
LED Display
The Mode and Port Selection Pushbuttons on the VE829’s front panel each
have three corresponding LED icons that represent audio, KVM, and USB
Link. These light green or orange, depending on status, as shown in the table,
below:
Note: 1. Make sure the source device has been powered on and that the signal
output is set to HDMI.
2. If there is no video displayed and OSD shows “Not Supported
Format”, the video resolution or frame rate from the source device is
not supported. Refer to page 29 for a list of supported video timing
formats.
Item / Mode
Status
Description
Power
LED
Source
LED
Video
LED
(VE829R)
Wireless
LED
(VE829R)
OSD
Display
Standby For power saving
mode.
Static
Red
off off off
Initial Boot
up / Warm
up
It will spend 15 ~ 20
seconds for system
boot up.
Blinking
Green
Blinking Blinking Blinking
Searching
available
channels
Continuing search
available channels
If system can’t
establish link over
80s after
initialization.
Blinking
Green
Blinking Blinking Blinking
Wireless
linked Mode
No input from
selected source
(Note B)
Static
Green
Blinking
(Quickly)
Blinking Static
Green
Video format not
recognized (Note
C)
Static
Green
Blinking
(Slowly)
Blinking Static
Green
Video format is
recognized
Static
Green
Static
Green
Static
Green
Static
Green
–