User manual

VM0808T User Manual

Setup

Click the Setup icon to configure the VM0808T’s IP and serial settings, and to

name all the ports in your installation.

IP Setup

The Web Setup settings enable you to configure the VM0808T’s Web interface

connection. Changes take a few seconds and automatically redirect you to the

IP address specified. Enter values and then click Save or Clear. Click Default

Setting to use the following defaults:

 IP Address – 192.168.168.23

 Subnet Mask – 255.255.255.0

 Default Gateway – 192.168.168.1

 Website Timeout – 5 minutes

Note: This option controls how long an inactive Web connection stays

logged in to the VM0808T. Any changes will take effect

immediately.

Telnet Configuration

Enable the checkbox if you want the VM0808T to receive commands on Port

23 for telnet use. See Telnet Operation, page 38, for further details.

Note: The VM0808T must be power cycled for a change in the Telnet

configuration block to take effect.

Serial Setup

The Serial Setup settings enable you to configure the VM0808T’s serial

connection. Use the drop-down menus to select values and then click Save or

Clear. Click Default Setting to use the following defaults:

 Serial Port Address – 0

 Baud Rate – 38400

 Serial Port Mode – RS-232

Note: Mode options are RS-232, RS-422/RS-485, and bypass. See Serial

Port Mode, page 24, for further details about bypass mode.