User manual

VS0201 / VS0401 User Manual
16
Standby Command
The Standby command puts the device in a power saving mode. The action is
the same as using the front panel or IR remote power button. When standby
mode is on or off either of the three methods (RS-232, front panel, or remote
control) can bring the device into or out off standby mode.
The formula for the Standby command is as follows:
1. Standby Command + Control [Enter]
For example, to put the device in standby mode, type the following:
standby on [Enter]
The following tables show the possible values and formats for the Standby
formulas:
Note: Each command can be separated with a space.
The following table lists the available commands:
Command Description
standby Standby command
Control Description
on Enable Standby mode
off Disable Standby mode (default)
Command Control Enter Description
standby on [Enter] Standby mode enabled
off [Enter] Standby mode disabled (default)