Instruction manual

IMP I IMP/P I SAM Hot Runner Controllers Instruction Manual
10
SafeChange. SafeChange should be enabled on
the controller before installing it in the mainframe to
reduce the possibility of damage to the controller.
Use of the SafeChange feature
does not eliminate the need for
careful installation and removal
of controllers. Always turn off
power to the controller and the
mainframe when installing or
removing a controller.
2) If the third position in the
connector block does
not contain a metal clip,
then the mainframe
does not support
SafeChange.You can
add a clip to convert
the mainframe.
3. Enabling the SafeChange Feature
Controllers are shipped
with SafeChange disabled,
because the controller will
not work if the SafeChange
feature is enabled, but
the mainframe does not
support SafeChange.
You can enable
SafeChange quickly
and easily.
To enable the
SafeChange feature,
remove the jumper block
from JP6.
Location of Clip in Mainframe
to Support SafeChange
Location of SafeChange
Jumper JP6