Instruction manual

IMP I IMP/P I SAM Hot Runner Controllers Instruction Manual

If you don’t see JP6, the

controller in hand may

pre-date the SafeChange

feature. In addition to JP6

in the location shown

above, controllers that

support SafeChange also

have one edge connector

shorter than the others. If all

the edge connectors are the

same length, the controller

does not support the

SafeChange feature.

4. Adding a SafeChange Clip to the Mainframe

You can convert an older mainframe to support

SafeChange. To make the conversion, you must add a clip

to the third position in the lower connector block (on the

backplane) in every slot; see the illustration. The clip is p/n

216D001U01.

To install the clip:

a. Turn off power to the mainframe.

b. Remove the back cover of the mainframe.

c. Position the clip in the third (open) position in the

lower connector block, and press. The clip will

snap into position.

SafeChange Edge Connector