Instruction manual

IMP IMP/P Hot Runner Controllers Instruction Manual
10
Location of Clip in Mainframe
to Support SafeChange
Location of SafeChange
Jumper JP6
2) If the third position in the
connector block does not
contain a metal clip, then the
mainframe does not support
SafeChange. You can add a
clip to convert the mainframe.
2. Enabling the SafeChange Feature
Controllers are shipped with
SafeChange disabled, because
the controller will not work if the
SafeChange feature is enabled,
but the mainframe does not
support SafeChange.
You can enable SafeChange quickly
and easily.
To enable the SafeChange
feature, remove the jumper
block from JP6.
If you don’t see JP6, the controller
in hand may pre-date the
SafeChange feature. In addition to
JP6 in the location shown above,
controllers that support SafeChange
also have one edge connector
shorter than the others. If all the
edge connectors are the same
length, the controller does not
support the SafeChange feature.
3. Adding a SafeChange Clip to
the Mainframe
You can convert an older mainframe
to support SafeChange. To make
the conversion, you must add a clip
to the third position in the lower
connector block (on the backplane)
in every slot; see the illustration.
The clip is p/n 216D001U01.
To install the clip:
a. Turn off power to the mainframe.
b. Remove the back cover of the
mainframe.
c. Position the clip in the third
(open) position in the lower
connector block, and press
The clip will snap into position.
SafeChange Edge Connector