User's Manual

ManualsBrandsATI Electronics ManualsElectronicsBT DRIVE FREE 211

ENGLISH

Charging the battery in the docking station

The docking station is charged via the USB cable. During the charging

process, the MF button of the docking station lights up red. the complete

charging of the docking station takes approx. 3 hours. The indicator of the

MF button switches o once the charging process is complete.

The docking station and headset are charged simultaneously if the headset

is in the docking station and the charging switch is switched on.

Important: Switching the charging switch on switches the headset o . An

existing connection to a cell phone is disconnected. The headset cannot

be used during the charging process.

Charging process completed

Disconnect the BT Drive Free 211 after the complete charging process from

the power supply.

Low battery power

If the charging state of the battery in the headset is very low, the MF button

lights up red in every operating state and 5 signal sounds can be heard every

20 seconds until the headset automatically switches o . The docking station

does not feature any warning indicator for low battery power. In this case, a

further operation is no longer possible and the headset cannot be charged

any longer via the docking station without external charger connection.

Battery information

Your device is operated with chargeable batteries. The lithium-ion-polymer

battery of the headset cannot be replaced. The lithium-ion battery of the

docking station can be replaced and is compatible with the Nokia battery

BL-5B. The full performance of a new battery is not achieved until after

two or three complete charging-discharging cycles. The battery can be

charged and discharged several hundred times, but it looses its capacity

over time.

Disconnect the BT Drive Free 211 from the power supply if you do not want

to charge the batteries. Disconnect a completely charged battery from

the charger since overcharging negatively impacts the service life of the

battery. If a battery is not used over an extended period of time, it looses

its capacity over time.

Important: Docking station and headset should be charged completely

if you do not use the devices for a longer period of time. To avoid a deep

discharge of the batteries, you should completely charge the Bluetooth

car kit every 2 months.

Switching BT Drive Free 211 on/o

Switching on

If the headset is switched o , press the MF button of the headset until you

hear 2 signal sounds and the MF button lights up blue 3 times. The headset

is switched on and the MF button  ashes blue.

Note: If the pairing with the BT Drive Free 211 was successful, the device

automatically connects with the last connected cell phone after switch-on.

For this purpose, the Bluetooth function of the cell phone must be activated.

The initial pairing is described below.

Switch-o

If the BT Drive Free 211 is switched on, press the MF button until you hear

2 signal sounds and the MF button lights up red for 3 seconds. The device

is switched o .

Registering (pairing) and connecting with the cell phone

Before you can use the BT Drive Free 211, you must register (pair) it with

a Bluetooth-ready cell phone and connect it. The BT Drive Free 211 can be

paired with two telephones, but connected only with one telephone at

a time. Pairing the headset can be done separately or together with the

docking station.

Note: If the headset is in the docking station, the MF button on the headset

and on the docking station has the same function.

Proceed as described to pair the BT Drive Free 211:

Hold the headset within range of a Bluetooth-ready cell phone; the

distance may not exceed one metre.

The headset must be switched o .

Press the MF button for approx. 5 seconds until you hear a signal sound

and the MF button intermittently  ashes red and blue.

–

02_BTDriveFree211_gb.indd 22-23

01.04.2011 17:36:08 Uhr